Car Emergency Starting Adapter for Makita for Dewalt for Bosch for Milwaukee for Ryobi for Devon for Worx Notice : Batteries are not included in this product, and the batteries and vehicles shown below are for display only The adaptors and designated lithium batteries can be used as emergency starting for your car. Please note: ( 1 ) . This adapter is only used for emergency starting when the car battery is fed. It should be removed immediately after the car starts to avoid damaging the battery. (2). When the adapter is plugged into the battery, it should avoid contact between the two clips. When not in use, it should be immediately removed from the battery to avoid damaging it. (3). This adapter cannot be used for other purposes Usage: (1). Connect the red clip of the adapter to the positive pole of the vehicle power supply, and connect the black clip to the negative pole; (2). Insert the adapter into the battery while the car starts, (3). Remove the battery and then the adapter Product Presentation : Well-adapted Low temperature startip, not afraid of the cold Product limit temperature is -50 ~ 80 Suitable for makita BL18XX 18V lithium battery, as shown in the picture below: Suitable for HongSong / FoGo / BoDa / Lomvum / ZhiPu / JiangMi 18V lithium battery, as shown in the picture below: Special note: Battery with such interface as ( for Makita ) bl1815g cannot be used, as shown in the figure below For DeWalt: Suitable for DeWalt XR 18V 20V FlexVolt 20V60V lithium batteries: DCB183 DCB203 DCB200 DCB206 DCB606 DCB609 DCB612 .