<p>With feature: Sensor cable could be extended to 50 meters. 0-99%RH control. Super high accuracy. Modbus RS485. Additional outputs: two for outputs.</p> <p>With function: Heating \/ Cooling mode option. Humidifying \/ de-humidifying mode option.</p> <p>Temperature and humidity output delay protection. Hight \/ low temperature \/ humidity alarm.</p> <p>Sensor failure alarm and outputs protection.</p> <p>Calibration for temperature and humidity. Output R1: Could be energized when over hot and\/or over wet. Could drive an air exhausting fan, or an alarming indicator.</p> <p>Two :</p> <p>One timer output is R1, could drive an air exhausting fan periodically.</p> <p>Another timer outputs R4 and R5 could drive such as incubator egg tray.</p> <p>R4 and R5 could be energized by keys, suitable for control the egg tray to any angle.</p> <p>Running status saving for power supply</p> <p>It is suitable for: Incubator control Swallow, swiftlet humidity control control and so on.</p> <p>Power supply: 100 ~ 240Vac, 50\/60Hz</p> <p>Accuracy: Temperature: 1% \/ 25</p> <p>Humidity: 3% (with the sensor -SHr05J), 2% (with the sensor -SHr05P)</p> <p>Setting range: Temperature: 0.0 ~ 65.0</p> <p>Humidity: 0 ~ 80%RH (when U9 = 0 for -SHr05J), 0 ~ 99%RH (when U9 = 1 for -SHr05P)</p> <p>Display range: Temperature: -20. ~ 80.0, Humidity: 0 ~ 99%RH</p> <p>Outputs:</p> <p>Temperature control: R3 5A</p> <p>Humidity control: R2 3A</p> <p>Multi-function: R1 3A</p> <p>Timer outputs: R4 and R5 1A</p> <p>Working environment: -10 ~ 45, no more than 85%RH, without dew</p> <p>Case dimension: W78 x H34.5 x D71 (mm)</p> <p>Installation drilling: W71 x H29 (mm)</p> <p>Protection level: IP65 (Front side only)</p> <p>Colour: Black</p> <p>material: plastic</p> <p>Package Contents:</p> <p>1 x Temperature Controller</p> <p>1 x sensor</p> <p>Only the above package content, other products are not included.</p> <p>Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.</p>