2X 10W Motorcycle Bike Turn Signal Indicator LED Load Resistor Decoder Fix Error Feature: new and. Lightweight and portable. and practical. Use plastic and won't do harm to human body. Input voltage: 12V Weight:55g Size:7x3x3cm Color:Black Applicable: For Bulbs up to 10 and 23 Material: Cement resistance Some motorcycles are modified LEDs because the power of the car halogen lamp is different from the power of the modified LED lamp. Therefore, the motorcycle will check that the power does not match, so there is a fault, no flash or strobe, etc. At this, an LED decoder must be installed to cancel the problem of the fault light alarm caused by the modification of the LED lamp. Some cars will change the LED lights to show that the turn signals will flash quickly, or do not flash the new installation of LED lights, etc. In order to solve this problem, the installation of this product can solve the flashing of the turn signal and the ED light failure alarm, motorcycle The car is suitable. The left and right lines of the turn signal are not the same. If you change the LED the left and right, you can install of the products on the left and right. If you change the lights before and, you can install two, but the front left and rear left turn signals ( Use a resistor) and the front right and rear right turn signals (with a resistor), connect the resistors with wires. For ease of installation, it is recommended to install resistor for each turn signal. Package list: 2 x 10W motorcycle LED decoder