Spectrum Analyzer 100khz To 960mhz,signal Generator Hand Held Frequency Mf/hf/vhf Uhf Input,2.8inch Touch Screen

849,00 zł
DARMOWA wysyłka

Spectrum Analyzer 100khz To 960mhz,signal Generator Hand Held Frequency Mf/hf/vhf Uhf Input,2.8inch Touch Screen

  • Marka: Unbranded
Sprzedawca:

Spectrum Analyzer 100khz To 960mhz,signal Generator Hand Held Frequency Mf/hf/vhf Uhf Input,2.8inch Touch Screen

  • Marka: Unbranded

849,00 zł

W magazynie
DARMOWA wysyłka
Sprzedawca:

849,00 zł

W magazynie
DARMOWA wysyłka

Akceptujemy następujące metody płatności

Opis

DIY Supplies : ELECTRICALSpectrum Analyzer 100Khz To 960Mhz,Signal Generator Hand Held Frequency MF/HF/VHF UHF Input,2.8Inch Touch Screen[ESD protection diode] A spectrum analyzer with two inputs, 0.1MHZ-350MHz high-quality MF/HF/VHF input, 240MHz-960MHz low-quality UHF input. Switchable resolution band pass filter, suitable for two ranges between 2.6kHz and 640kHz.[Frequency range] Use a resolution filter to isolate the input power in a small frequency range. The fastest scanning speed occurs at RBW or 300kHz or wider frequencies, about 2 scans per second. The resolution filter scans in the desired frequency range. But as the frequency span increases and the RBW decreases, the scanning speed decreases rapidly. It takes about 2 minutes to scan from 0MHz to 350MHz with an RBW of 10kHz.[4 input/output specification modes] The input/output specification of tinySA is divided into 4 modes: low input mode, high input mode, low output mode, and high output mode. The firmware of tinySA can be updated by the user. If you need a new version of the firmware, please contact us for the download link.[Built-in calibration signal generator] This network analyzer can be used as a signal generator. When it is not used as a spectrum analyzer, the MF/HF/VHF sine output is between 0.1MHZ-350MHz, and the UHF square wave output is between 240MHz-960MHz. The color display shows 290 scanning points, covering the entire low-frequency or high-frequency range. The built-in calibration signal generator is used for automatic self-check and low-input calibration.[PC Control]Connect to PC via USB to become a PC-controlled spectrum analyzer. The USB interface implements the Serial over USB (CDC) protocol, and there are a large number of commands that can be called through the serial interface. These commands can be used to perform measurements or update internal settings. After connecting to a Windows PC, the Windows driver will be installed automatically. The Linux driver is built into the kernel.Material:Metalcolour:BlackPackage Contents:1 set x Spectrum AnalyzerOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
  • Identyfikator Fruugo: 227407681-485060217
  • EAN: 889614584904

Dostawa i zwroty

Wysyłka w ciągu 3 dni

  • STANDARD: BEZ OPŁAT - Dostawa między śr. 05 listopada 2025–wt. 11 listopada 2025 - BEZ OPŁAT

Wysyłka z Chiny

Dokładamy wszelkich starań, aby zamówione produkty były dostarczane w całości i zgodnie z Państwa wymaganiami. Jeśli jednak otrzymają Państwo niekompletne zamówienie, przedmioty inne niż zamówione lub istnieje inny powód, dla którego nie są Państwo zadowoleni z zamówienia, mogą Państwo zwrócić zamówienie lub dowolne produkty objęte zamówieniem i otrzymać pełny zwrot kosztów za te przedmioty. Pokaż pełną politykę zwrotów

Szczegóły zgodności produktu

Prosimy o zapoznanie się z informacjami dotyczącymi zgodności dotyczącymi tego produktu podanymi poniżej.

Poniższe informacje zostały dostarczone przez niezależnego sprzedawcę zewnętrznego sprzedającego ten produkt.

Producent:
Poniższe informacje zawierają dane kontaktowe producenta danego produktu sprzedawanego w serwisie Fruugo.

  • Fuzhouhaichengshengchangmaoyiyouxiangongsi
  • Fuzhouhaichengshengchangmaoyiyouxiangongsi
  • maweiqu junzhulu83hao kaifaqukejifazhanzhogxindalou disiceng E481shi
  • Fuzhou
  • CN
  • 350015
  • 755120680@qq.com
  • 8615280094726

Osoba odpowiedzialna w UE:
Poniższe informacje zawierają dane kontaktowe osoby odpowiedzialnej w UE. Osobą odpowiedzialną jest wyznaczony przedsiębiorca z siedzibą w UE, który jest odpowiedzialny za wypełnianie obowiązków związanych z przestrzeganiem przepisów w odniesieniu do danego produktu sprzedawanego na terenie Unii Europejskiej.

  • EC REP SERVICES SL
  • EC REP SERVICES SL
  • C/GRAN VIA 49, 7 DCH
  • MADRID
  • ES
  • 28013
  • ECREPSERVICE@HOTMAIL.COM
  • 34 910563102