Tab5 is integrates a dual-SoC architecture and abundant . Its main controller is the RISC-V-based ESP32-P4 SoC, equipped with 16 MB Flash and 32 MB PSRAM; the wireless module uses ESP32-C6-MINI-1U, supporting Wi-Fi 6 with an antenna system that can switch between a built-in 3D antenna and an external MMCX antenna port, flexibly adapting to different deployment environments and ensuring high data throughput and low latency. For visuals and interaction, Tab5 features a 5inch 1280x720 IPS TFT display driven over MIPI-, with touch input handled by the GT911 multi-touch controller (IC) for smooth, precise response. A MIPI--connected SC2356 2 MP camera (1600x1200) enables HD video capture, image processing, and edge AI applications (e.g., face recognition, object tracking). I/O and expansion include USB-A (Host) and USB-C (USB 2.0 OTG) ports for traditional peripherals; industrial communication via -485 (SIT3088 with switchable 120 termination); 1 x GROVE, 1 x M5BUS, GPIO_EXT header, and a Micro-SD slot; plus a STAMP solder-pad for Cat.M/-IoT/LoRaWAN modules. A Reset/Boot button allows quick reset and firmware flashing. Audio/video uses an ES8388 audio codec with ES7210 front end, dual-mic array, 3.5 mm jack, and 1 W 8 NS4150B speaker for high-fidelity recording and playback. The onboard BMI270 six- sensor (+gyro, interrupt ) can trigger MCU on motion. Time and power management integrate an RX8130CE real-time clock (interrupt ); a 2S NP-F550 removable Li-ion battery(without); and IP2326 charging, MP4560 buck-boost, and INA226 real-time monitoring circuits to stable operation without external power. A side-mounted Power button provides one-touch on/off. (Different batches may result in different printing screens, which not affect the use) Color: White Material: plastic Package Contents: 1 * Tab5 IoT Controller Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.