EBay For EMID & Card Dual Frequency Access Control Card Reader,Wiegand26/348137 Product Name: Dual-frequency access control reader; Operating Frequency: 125Khz, 13.56Mhz; Sensing distance: 0-15CM; Operating voltage: DC5-16V; Operating Current: Static Less than 30mA;Dynamic Less than 40mA; Communication format: Wiegand26/34, UART TTL; Working humidity: 10%~90%; Baud rate: 9600.8.1; Working temperature: -30℃~85℃; Ways of identifying: Swipe card Card reading types: IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(Does not support HID, Cobra, APCiK, etc.)IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(Does not support HID, Cobra, APCiK, etc.) Installation precautions: from the card reader to the controller: It is recommended to use an 8-core shielded multi-strand twisted pair network cable (two of which are spare, if the card reader light feedback legal card is not required, the LED cable can not be connected, if the buzzer of the card reader is not used) The Buzzer line can not be connected to the illegal card feedback from the device), and the data lines Data1 and Data0 are a pair of twisted pairs. The wire diameter is recommended to be more than 0.3 Square millimeters. The can not exceed 100 meters. The shield wire is connected to the GND of the controller. The card reader is installed on a metal. Since the card reader is a radio frequency product, the metal pair near the front or the rear absorb its radio frequency signal. If the metal is large, it even affect the card reader. Card, or the reading distance is very attenuated. The distance between the two card also affect the card reader, some shorten the card reading distance, and some cause the two card to read the card at the same time or the card reader cannot read the card. Solution: Try not to insta