1Adopting high quality stainless steel material, corrosion-resistant, long service life. 2The product is used to measure the fluid dynamic state of the flow through the pipeline, such as: water, ethylene dilute, ethylene glycol and other liquids that have no corrosive effect on copper. 3When flow rate exceeds set value, fluid drives blade and micro switch, the SPDT contact can connect a circuit and disconnect other circuit. 4The flow switch is usually used in places that require interlock or 5Apply to water treatment system, central air conditioning, water cooling unit, fire protection system and other fields. Features: Adopting high quality stainless steel material, corrosion-resistant, long service life.The product is used to measure the fluid dynamic state of the flow through the pipeline, such as: water, ethylene dilute, ethylene glycol and other liquids that have no corrosive effect on copper.When flow rate exceeds set value, fluid drives blade and micro switch, the SPDT contact can connect a circuit and disconnect other circuit.The flow switch is usually used in places that require interlock or "cut-off" protection.Apply to water treatment system, central air conditioning, water cooling unit, fire protection system and other fields.Specification: Condition: 100% Material: Stainless steel & Plastic Weight: 518g/18.3oz Voltage: 220V Interface size: 1" Control mode: Paddle Maximum working pressure: 1.0mpa Ambient temperature: 0C~60C Liquid temperature: -10c-100c (non-freezing) Micro switch: single pole double throw (SPDT) Contact life: 100, 000 times Electrical parameters of micro - switch: 220VAC, 15A Installation method: 1. Open the flow switch 2. The switch has been set at minimum flow rate. Turn the adjusting screw counterclockwise to increase the flow setting value. 3. Press the target to check whether the micro switch can work normally. Excessive clockwise rotation of the adjusting screw may lead to the failure of the flow switch. 4. After the installation, please press the lever of the flow switch several times to check. If there is no "click" sound, turn the adjusting screw counterclockwise until there is "click" sound. 5. The adjustment screw of lacquer seal is only used for the first time to adjust the state of flow switch. Please do not change or adjust it. 6. Observe three operating cycles to ensure that the switch and the system to which it is connected are operating properly and cover the switch enclosure promptly. Package List: 1 * Water Flow Switch 5 * Paddle Note: 1. Please check the flow switch carefully before installation. 2. Flow switch can be installed in horizontal pipeline or vertical pipeline with upward liquid flow direction, but not in pipeline with downward liquid flow direction. When installed in the pipeline with upward liquid flow direction, the gravity effect should be considered. 3. HFS flow switch could not be used in the pipe which liquid temperature below freeing point. 4. Arrester must be installed if quick-closing valve fixed downstream. 5. When installing wiring, please pay attention to the following matters: (1). It is absolutely forbidden to impact the wrench on the switch base plate, which will lead to the deformation and failure of the flow switch. (2).