FTDI FT232RL RS485 USB TO DSUB 15PIN DB15 MALE ADAPTER PLC PROGRAMMING CABLE FOR SIEMENS SIMATIC S7 CP341 INTERFACE TO PC with a 1.8 meter length provides a reliable USB to RS485 bridge for Siemens SIMATIC S7 CP341 interfaces and other RS485 devices. Built around the FTDI FT232RL USBUART bridge, this adapter enables a PC to communicate with RS485 devices through a DB15 male connector, making PLC programming, monitoring, and diagnostics straightforward. Key benefits Facilitates PC communication with Siemens SIMATIC S7 CP341 RS485 interfaces, enabling programming and diagnostics from a PC. Uses the FTDI FT232RL chip, ensuring broad driver support via FTDI VCP and reliable data transfer. DB15 male RS485 port supports standard RS485 networks, enabling connection to PLCs, sensors, meters, and other RS485 devices. Cable length of 1.8 meters provides flexible installation and usable reach in typical control panel and bench setups. Simple setup with standard FTDI drivers; plug in to a PC and begin communication after driver installation. Compact, practical design suitable for lab, test bench, and factory floor use. Key attributes Interface: USB to RS485 Connector: Dsub 15pin (DB15) male on RS485 side Chip: FT232RL (FTDI USBUART bridge) Cable length: 1.8 meters Target compatibility: PC to Siemens SIMATIC S7 CP341 interface communications; general RS485 devices Documentation and driver support: FTDI VCP compatible Applications and use cases Siemens SIMATIC S7 CP341 interface to PC: Direct PC connectivity for programming, monitoring, and diagnostics of CP341 RS485 communications. RS485 device testing and debugging: Connect a PC to RS485 peripherals such as Modbus RTU sensors, meters, or industrial controllers for configuration and troubleshooting. PLC network commissioning: Use during setup and validation of RS485 based networks in automation projects, allowing quick PC access to field devices and controllers. Setup and compatibility notes Requires FTDI USB drivers (VCP) on the PC for reliable operation. Connect the USB end to the PC and the DB15 RS485 end to the CP341 port or RS485 device, ensuring proper bus wiring and terminators as required by the RS485 network. Compatible with standard RS485 communication protocols and typical baud rates supported by FT232RL based adapters. This USB to RS485 adapter provides a straightforward, dependable solution for linking a PC to Siemens SIMATIC S7 CP341 RS485 interfaces and other RS485 devices, with a practical 1.8 meter cable length and FTDI driven compatibility for broad driver support.