Angle 90 Lambda O2 Oxygen Sensor Extender Spacer For Decat Hydrogen

64,00 zł
+ 54,99 zł wysyłka

Angle 90 Lambda O2 Oxygen Sensor Extender Spacer For Decat Hydrogen

  • Marka: Unbranded
Sprzedawca:

Angle 90 Lambda O2 Oxygen Sensor Extender Spacer For Decat Hydrogen

  • Marka: Unbranded

64,00 zł

Oszczędzasz 65,00 zł (50%)

Sugerowana cena detaliczna

129,00 zł
W magazynie
+ 54,99 zł wysyłka
Sprzedawca:

64,00 zł

Oszczędzasz 65,00 zł (50%)

Sugerowana cena detaliczna

129,00 zł
W magazynie
+ 54,99 zł wysyłka

Akceptujemy następujące metody płatności

Opis

In vehicles with EURO 3 and higher vehicle emissions standards the second lambda oxygen sensor emulator is located after the catalytic converter. It plays a diagnostics role.If it detects any irregularities on the basis of the data from the engine control unit it displays an error on the dashboard and the engine can switch into emergency mode (depending on the make of car).It is often manifested by big drop. These problems arise in the event of removal of the catalyst, its low efficiency, or its replacement with jet pump. In such situations, it becomes necessary to mount THE SECOND OXYGEN SENSOR EXTENDER.The catalyst can effectively reduce the output of 2 to 3%, and the maximum speed of up to 5%. Its removal and the use of emulator is the easiest way to low-cost raise of ; The emulator can also help in case of problems with the LPG installation, which due to the detection of very mixture will display the CHECK ENGINE on the dashboard.Polished front surfaces enabling perfect tightening.Washer in the set, ability to adjust the angle of screwing in the extender.Threads are made with dedicated tool, perfect accuracy and repeatability.Exhaust gas inlet hole 2 mm; In extreme situations narrowing of the inlet hole prevents motor failure (driving at high speed).Perfect for tight awkward spaces, where there is no room for the straight extendersInstallation:Unscrew the lambda oxygen sensor, screw in the emulator in its place and then screw in the oxygen sensor.Extenders are fromInternal and External Thread: M18x1.5Height: 40mmWeight: 130g colour:Brass colorMaterial:metalPackage Contents:1 * Oxygen Sensor Extender1 * washerOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
  • Identyfikator Fruugo: 334118106-736434325
  • EAN: 4229592807453

Informacje o bezpieczeństwie produktu

Prosimy o zapoznanie się z informacjami dotyczącymi bezpieczeństwa produktu określonymi poniżej

Poniższe informacje zostały dostarczone przez niezależnego sprzedawcę zewnętrznego sprzedającego ten produkt.

Etykiety bezpieczeństwa produktu

CE Mark
Ostrzeżenia dotyczące bezpieczeństwa: WARNING! TO AVOID DANGER OF SUFFOCATION,KEEP AWAY FROM BABIES ANDCHILDREN. DO NOT USE IN CRIBS/BEDSOR PLAY PENS. THIS BAG IS NOT A TOY.

Dostawa i zwroty

Wysyłka w ciągu 24 godzin

  • STANDARD: 54,99 zł - Dostawa między czw. 30 października 2025–śr. 05 listopada 2025

Wysyłka z Chiny

Dokładamy wszelkich starań, aby zamówione produkty były dostarczane w całości i zgodnie z Państwa wymaganiami. Jeśli jednak otrzymają Państwo niekompletne zamówienie, przedmioty inne niż zamówione lub istnieje inny powód, dla którego nie są Państwo zadowoleni z zamówienia, mogą Państwo zwrócić zamówienie lub dowolne produkty objęte zamówieniem i otrzymać pełny zwrot kosztów za te przedmioty. Pokaż pełną politykę zwrotów