1、Frequency Band: The working frequency can range from 50Hz to 3.8GHz, suitable for broadband power detection, with flat input and output responses. 2、High Dynamic Range: The input dynamic range can get to 65dB, and in a 50 day system, its input signal can range from -75 dBm to 16 dBm. High accuracy and linearity provide an accurate linear output voltage in dB, 50mV per dB. 3、Wide Utility: True RMS power detection AD8362 is a power detector with true RMS response. Its measurement results are independent of the signal waveform and can detect the RF power of complex modulated signals, including CDMA, W CDMA, 8PSK, QAM, and 0FDM signals. It is suitable for IS95, CDMA2000, 3GPP, GSM/EDGE, MMDS, and other broadband access devices. 4、Power Measurement Mode: The VOUT and VSET pins are directly connected, and the output voltage is proportional to the logarithm of the effective value of the input power. For every 1dB increase in the input signal, the output voltage Vout increases by 50 mV, up to Vs 0.1 V. The voltage reading directly reflects the power. This working mode is suitable for use as a power meter or for power detection in equipment. 5、Controller Mode: Set a reference voltage value at the VSET end. When the power voltage value detected by AD8362 is greater than the reference voltage value, the voltage Vout outputs a high level. When the power voltage value detected by AD8362 is less than the reference voltage value, the voltage Vout uses AD8307 to measure power. The typical linear slope is 0.025V/dB, and the measurement range is -75 dBm to +16 dBm.. Equipped with shielding shell and anti reverse connection protection diode. Item Type: RF Signal Power Meter Material: Aluminum Alloy Model: AD8362 Power Supply Voltage: DC 6V-15V Frequency: 50Hz-3.8GHz Dynamic Range: 65dB Frequency Detector: -75dBm - 16dBm 1 x RF Signal Power Meter