DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

139,00 zł
DARMOWA wysyłka

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Marka: Unbranded
Sprzedawca:

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Marka: Unbranded

139,00 zł

Oszczędzasz 90,00 zł (39%)

Sugerowana cena detaliczna

229,00 zł
W magazynie
DARMOWA wysyłka
Sprzedawca:

139,00 zł

Oszczędzasz 90,00 zł (39%)

Sugerowana cena detaliczna

229,00 zł
W magazynie
DARMOWA wysyłka

Akceptujemy następujące metody płatności

Opis

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as ARM test development board. Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, With automatic, regular and one-shot modes, easy to capture the moment waveform. Comes 1Hz or 3.3V square wave test signal source. With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX. or MIN. or AVG. or Peak- Maximum real-time sampling rate: 1Msps Accuracy: 12Bit Sample buffer depth: 1024 bytes Analog Bandwidth: 0 - 200KHz Vertical Sensitivity: 10mV or Div - 5V or Div (in 1-2-5 increments) Adjustable vertical displacement with indication Input impedance: 1MΩ Maximum input voltage: 50Vpp (1:1 probe), 400Vpp (10:1 probe) Coupling methods include DC or AC or GND Horizontal time base range: 10μs or Div - 50s or Div (in 1-2-5 increments) With automatic, conventional and single trigger modes, it is convenient to capture instantaneous waveforms Trigger with rising or falling edge Adjustable trigger level position with indication Waveform before trigger can be observed (negative delay) Waveform display can be freeze at any time (HOLD function) Comes with 1KHz or 3.3V square wave test signal source Digital display with waveform parameters, the parameters that can be displayed are: frequency, period, pulse width, duty cycle, maximum value, minimum value, average value, peak-to-peak value, RMS Save or recall the waveform, the waveform does not disappear when power off Colour:Red Material:ABS Size:18 x 12.5 x 3cm Package Contents: 1 x DSO138 DIY Digital Oscilloscope Kit 1 x Probe Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different f Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.
  • Identyfikator Fruugo: 445967718-936504096
  • EAN: 7438599604249

Dostawa i zwroty

Wysyłka w ciągu 2 dni

  • STANDARD: BEZ OPŁAT - Dostawa między pon. 22 grudnia 2025–pon. 29 grudnia 2025 - BEZ OPŁAT

Wysyłka z Chiny

Dokładamy wszelkich starań, aby zamówione produkty były dostarczane w całości i zgodnie z Państwa wymaganiami. Jeśli jednak otrzymają Państwo niekompletne zamówienie, przedmioty inne niż zamówione lub istnieje inny powód, dla którego nie są Państwo zadowoleni z zamówienia, mogą Państwo zwrócić zamówienie lub dowolne produkty objęte zamówieniem i otrzymać pełny zwrot kosztów za te przedmioty. Pokaż pełną politykę zwrotów

Szczegóły zgodności produktu

Prosimy o zapoznanie się z informacjami dotyczącymi zgodności dotyczącymi tego produktu podanymi poniżej.

Poniższe informacje zostały dostarczone przez niezależnego sprzedawcę zewnętrznego sprzedającego ten produkt.

Producent:
Poniższe informacje zawierają dane kontaktowe producenta danego produktu sprzedawanego w serwisie Fruugo.

  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei City, Anhui Province, Shushan District, Anhui Province, No. 15, South Seventh Street, South Cooperative South Road, Chemical Machinery Community, Building 1, Unit 2, 603
  • Hefei
  • CN
  • 523011
  • nacufalacan81@hotmail.com
  • 13243801962

Osoba odpowiedzialna w UE:
Poniższe informacje zawierają dane kontaktowe osoby odpowiedzialnej w UE. Osobą odpowiedzialną jest wyznaczony przedsiębiorca z siedzibą w UE, który jest odpowiedzialny za wypełnianie obowiązków związanych z przestrzeganiem przepisów w odniesieniu do danego produktu sprzedawanego na terenie Unii Europejskiej.

  • Jean Luc
  • In Memoria Futuri SAS
  • 3 RUE DU PAS DE LA MULE 75004 PARIS
  • Paris
  • France
  • 75004
  • infoapexchen@gmail.com
  • 33745713901