PS1248G 4Pairs High-Power active splitters enable data terminals that were not originally designed to accept powerfrom the Ethernet, to be powered by Power over Ethernetmidspans. The PDAS- PS1248-4P splitter can power devices such as WiMAX CPEs, small WiMAXbase-stations, 802.11n Access-Points, Thin- Clients, PTZ (Pan/Tilt/Zoom) IP Cameras, Video-Phones and more.Moreover, such devices might only accept voltage levels lower than the PoE standard minimum voltage (44v in IEEE802.3af / 50v in 802.3at). Using the PS1248-4P splitter, these terminals immediately become PoE- without any modification required on their side. The splitter is identified as a powered device (PD) in front of the powering Midspan and after being detected and powered, it physically splits the data and power streams, arriving over a single cable, into wo separate (LAN & DC) which go directly to the data terminal. Voltage regulation is also performed to the level required by the terminal .Connectors: 2 x RJ-45, shielded, EIA 568A and 568B DC Jacks On unit: 5.5X2.1mmData Rate: 10/100/1000Input voltage: 44 - 57 Input power: 60W maxOutput power: 51W maxOutput Current: 4.2A@12VIndicators :Output Power Indicators: Green LED Environmental Operating Temp: -20 to 40 CelsiusStorage Temp: -30 to 70 CelsiusOperating Humidity: 10% to 90%, non-condensingStorage Humidity: 5% to 95%, non-condensingcolour:blackmaterial:metalsize:8 x 6.2 x 2.7 CmPackage Contents:1xPS1248G Gigabit POE splitterOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.