Automatically charges the battery. The rectifier and brake circuit of this controller uses an integrated module, offering improved heat dissipation and reliability compared to traditional designs. Features a fully sealed, waterproof design with IP67 protection rating, allowing for long-term operation even in wet conditions. Note: Ensure the output voltage of the wind turbine generator matches the rated voltage of the battery. Connect wiring in the following order: first connect the battery's positive and negative terminals to the controller, then connect the three-phase output from the wind turbine. Follow instructions carefully when connecting the battery and wind turbine to the controller. Reversing polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the battery's positive and negative terminals to the corresponding red (positive) and black (negative) terminals on the controller. 2. Connect the three-phase output wires from the wind turbine to the three-phase input terminals (green wires) on the controller. Specifications: - Maximum input AC voltage: AC35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ±0.3V / 29V ±0.3V - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ±0.3V / 29V ±0.3V - Protection level: IP67 - Static power consumption: 0.008A - Maximum load power: 800W - Maximum bearing wind speed: 12 m/s - Operating temperature range: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Compatible with 12V and 24V systems - Installation: Bolted mounting - Do not reverse the positive and negative terminals to prevent damage to the controller Application: Wind charge controller Color: Blue Material: Aluminum alloy Package includes: 1 x MPPT Wind Generator Controller Note: Other items shown in images are not included. Due to lighting effects and monitor settings, the actual color of the item may vary slightly from images. Measurement tolerance: ±1–3 cm.