Signal generator module Key benefits Provides a stable, adjustable 0–10 V analog output for testing, simulation, and control input needs. Simplifies interfacing with PLCs, MCUs, and industrial controllers by matching common 0–10 V analog input standards. Built-in output current limit reduces risk of overloading downstream circuits during bench testing or integration. Main features and performance Output range: adjustable 0–10 V analog voltage. Maximum output current: approximately 10 mA. Input voltage requirement: input must be at least 2 V higher than the desired analogue output. Maximum allowed input voltage: 30 V. Module form factor for system or bench integration. Compatibility and use Supports standard 0–10 V analogue interfaces used by most PLCs, MCUs, and industrial controllers. Works as a direct drop-in for control panels, data acquisition systems, and automation equipment that accept a 0–10 V input. Typical applications PLC and industrial controller input simulation: generate precise 0–10 V signals for commissioning, calibration, and functional testing. MCU and embedded development: emulate sensor outputs or provide reference voltages when a DAC is unavailable or for rapid prototyping. System troubleshooting and maintenance: isolate and test analogue input channels without modifying the primary control system. Integration notes and precautions Ensure the module input voltage is always at least 2 V above the required output level and does not exceed 30 V. Observe the approximate 10 mA maximum output current to avoid overloading the module or the device under test. Confirm compatibility with the target controller’s input impedance and wiring practices before permanent installation.