Motorcycles Display Speed Display Gears 1-6 For HONDA VTR1000 VTR 1000 SP1 SP1 VTR1000F FireStorm SuperHawk VTR 1000 F -- Description: Product condition: 100% brand new Product material: LED and ABS plastic Color: blue, green, orange, red and white Quantity: one piece Easy to install, including installation instructions. Equipment: For HONDA VTR1000 SP1/SP2 (2000-2006) For HONDA VTR1000F FireStorm/SuperHawk (1997-2005) -Product installation and positioning methods. You need to configure this module after installation. Only do setup when the engine is warm so that the idle speed is normal, find a long, straight road with light traffic. The unit does not learn the same hardware twice, it makes it easy to set up on the road. If necessary, you can even swipe the wd oacute; and pause during setup. Don't stare at the display, watch the road and drive with the utmost care as always! -Turn on the ignition. It will count backwards (6 to 1), which means the memory is clear. -When 'l' is flashing, keep your eyes on the engine in neutral and allow the engine to idle. -Display will flash ''1''. Select first gear, release the clutch and keep the engine speed above idle. The display flashes faster while the device learns the hardware. -When display shows ''2'', select two-position. -Repeat this process until all runs have been thought of (5 or 6). -The unit is programmed and should indicate the gears correctly. -Now when the ignition is turned on, it will display forward (1 to 6), indicating that it is fully functional. Product installation instructions and photos: Locate the connector under the fuel tank or under the seat. The green cable connects to the motorcycle crankshaft sensor cable. Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-Minnanxin