Waveshare ST-LINK/V2 , STM Programmers & Debuggers

Waveshare ST-LINKV2 , STM Programmers & Debuggers Description 1. The ST-LINKV2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAGserial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. 2. STM8 applications use the USB full speed interface to communicate with STMicroelectronics ST Visual Develop (STVD) or ST Visual Program (STVP) software. 3. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. Key Features 1. 5V power supplied by a USB connector 2. USB 2.0 full speed compatible interface 3. USB standard A to mini B cable 4. SWIM specific features 5. 1.65 V to 5.5 V application voltage supported on SWIM interface 6. SWIM low-speed and high-speed modes supported 7. SWIM programming speed rate: 9.7 Kbytess in low speed and 12.8 Kbytess in high speed 8. SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector 9. SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector 10. JTAG specific features 11. 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs 12. JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector 13. Direct firmware update feature supported (DFU) 14. Status LED which blinks during communication with the PC 15. Operating temperature 0 to 50 °C Application Example Connecting the PC and STM8STM32 application board through ST-LINKV2 to establish hardware connection Connection with STM8 applications The ST-LINKV2 should be connected to the STM8 application via the SWIM cable. Two SWIM cables are delivered with the product: - SWIM flat ribbon with a standard ERNI connector at one end and a 4-pin connector at the other end - SWIM flat ribbon ended with a 4-pin, 2.54 mm, low-cost connector on two sides Connection with STM32 applications For STM32 developments the ST-LINKV2 must be connected to the application using the standard 20-pin female-female JTAG flat ribbon provided. ST-LINKV2 Status The LED labeled COM on top of the ST-LINKV2 shows the ST-LINKV2 status (whatever the connection type). When the: 1. LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found. 2. LED is RED: communication between ST-LINKV2 and the PC is established (end of enumeration). 3. LED is blinking GREENRED: data are being exchanged between the target and the PC. 4. LED is GREEN: the last communication has been successful. 5. LED is ORANGE: ST-LINKV2 communication with the target has failed.